Vicon Extra 832T PRO - User Manual

Questions and Answers

V
Vincent ThomasAug 8, 2025
Why are there stripes in the stubble when using Vicon Farm Equipment?
- D
  dominguezjessicaAug 8, 2025
  Stripes in the stubble when using Vicon Farm Equipment can occur if the cutterbar isn't correctly angled for the crop. In this case, adjust the angle of the cutterbar. Also, stripes can appear if the cutterbar is fitted with high skids; remove the high skids. A build-up of crop on the cutting discs can also cause stripes, so increase your speed. Mounting throwing wings on the cutting discs or setting the rotor to 900 rpm can also help.
K
kristin14Aug 13, 2025
What to do if the hydraulic functions on my Vicon Extra 832T PRO Farm Equipment aren't working?
- K
  Kevin LloydAug 14, 2025
  If the hydraulic functions on your Vicon Farm Equipment aren't working, first, check that the hydraulic hoses are correctly connected to the tractor's hydraulic outlet. Also, make sure that the tractor hydraulics are engaged.
G
gmortonAug 18, 2025
Why is the stubble uneven when using Vicon Farm Equipment?
- L
  lewissamanthaAug 18, 2025
  Uneven stubble with Vicon Farm Equipment can be caused by several factors. You might be driving too slowly, so increase your speed. The tractor RPM on the PTO might be too low, so check the RPM. Also, check if the knives are blunt or missing, and turn or replace them as needed. Finally, the machine may not be correctly balanced, so adjust the springs.
S
Sandra NashAug 23, 2025
How to fix uneven swathes with Vicon Farm Equipment?
- H
  Hannah KelleyAug 23, 2025
  If you're getting uneven swathes with your Vicon Farm Equipment, it could be due to the rotor's RPM being too low; set the rotor to 900 rpm. Another cause could be an incorrect setting of the deflector plate, so adjust the deflector plates.
K
karen84Aug 28, 2025
What to do if my Vicon Farm Equipment is sloping to the rear during mowing?
- S
  Stephanie PalmerAug 28, 2025
  If your Vicon Farm Equipment is sloping to the rear during mowing, it could be due to too much downward pressure on the cutterbar. Adjust the springs to correct this.
J
Joy GreenSep 2, 2025
What causes violent shocks during road transport of Vicon Extra 832T PRO?
- E
  Eric Bell Jr.Sep 2, 2025
  Violent shocks during road transport of Vicon Farm Equipment can occur if the machine's accumulator has too little pressure or is defective; check or replace the accumulator. Also, make sure the safety valve is open.