Assembly - attachment
40
First start-up of
machine
The initial test drive of the machine is important
When the machine is connected to the tractor for the first time it must
be test driven.
Attention will assure yours and others safety.
Failure to follow the safety instructions may result in serious injuries.
Do not remove the protection guards
Check that all protective guards are in place before use.
This assures that the machine will offer maximum protection to the
operator.
If the safety guards are removed or not used it may result in serious
injuries and accidents.
The side guard for the cutting unit must be correctly positioned
before start up
The side guard for the cutting unit must be folded out and correctly
positioned before the machine is started.
This ensures that the machine will give maximum protection to the
operator.
Moving objects may cause serious injuries and accidents.
Check that the machine's protections are in place.
Check that the side guard on the cutting unit are folded out and
correctly positioned.
Check that the mechanical safety valve is open.
Carefully connect the tractor's PTO shaft.
Carefully increase the speed on the PTO shaft to 540/1000 RPM.
»Number of revolutions on the PTO« page 30
Check that the machine runs even without any vibrations.
Return the PTO shaft to idle speed.
Activate all the hydraulic functions of the machine, one by one.
Disconnect the tractor's PTO shaft.
To Next Page
Loading...
