Vicon Extra 828T PRO - User Manual

Questions and Answers

D
Donald HillAug 5, 2025
Why are there stripes in the stubble when using Vicon Extra 828T PRO?
- H
  Hannah CooperAug 6, 2025
  Stripes in the stubble when using Vicon Farm Equipment can occur if the cutterbar isn't correctly angled for the crop. In this case, adjust the angle of the cutterbar. Also, stripes can appear if the cutterbar is fitted with high skids; remove the high skids. A build-up of crop on the cutting discs can also cause stripes, so increase your speed. Mounting throwing wings on the cutting discs or setting the rotor to 900 rpm can also help.
K
Kenneth JuarezAug 10, 2025
What to do if the hydraulic functions on my Vicon Extra 828T PRO aren't working?
- D
  Donald MooreAug 10, 2025
  If the hydraulic functions on your Vicon Farm Equipment aren't working, first, check that the hydraulic hoses are correctly connected to the tractor's hydraulic outlet. Also, make sure that the tractor hydraulics are engaged.
C
Christopher MorrowAug 16, 2025
Why is the stubble uneven when using Vicon Extra 828T PRO?
- C
  ctaylorAug 16, 2025
  Uneven stubble with Vicon Farm Equipment can be caused by several factors. You might be driving too slowly, so increase your speed. The tractor RPM on the PTO might be too low, so check the RPM. Also, check if the knives are blunt or missing, and turn or replace them as needed. Finally, the machine may not be correctly balanced, so adjust the springs.
A
Andrea FlowersAug 21, 2025
How to fix uneven swathes with Vicon Farm Equipment?
- A
  Alex AliAug 21, 2025
  If you're getting uneven swathes with your Vicon Farm Equipment, it could be due to the rotor's RPM being too low; set the rotor to 900 rpm. Another cause could be an incorrect setting of the deflector plate, so adjust the deflector plates.
P
Patrick HensonAug 26, 2025
What to do if my Vicon Extra 828T PRO is sloping to the rear during mowing?
- K
  Kristina GrayAug 27, 2025
  If your Vicon Farm Equipment is sloping to the rear during mowing, it could be due to too much downward pressure on the cutterbar. Adjust the springs to correct this.
M
Matthew SaundersAug 30, 2025
What causes violent shocks during road transport of Vicon Farm Equipment?
- J
  John ReedAug 30, 2025
  Violent shocks during road transport of Vicon Farm Equipment can occur if the machine's accumulator has too little pressure or is defective; check or replace the accumulator. Also, make sure the safety valve is open.