EasyManua.ls Logo

Vicovation Vico Power-Plus - Detailed Temperature Setting; Setting Over-Temperature Threshold

Vicovation Vico Power-Plus
59 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
22
Temperature Setting determines the over-temperature cut-off
protection threshold. Default is off. You may setup different
value depending on your location climate. During summer time,
if outside temperature is over 35°C (95°F), it might be over
70°C (158°F) in car without air-conditioner when parking
outside under sunlight. You may setup your temperature
threshold value based on parking environment.
Special Notice: Please avoid Power-PLUS placement under
direct sunlight. Or it might lead to electronic component
failure, or abnormal function/failure by incorrect
measurement.
You may select 50°C/55°C/60°C/65°C/70°C/75°C or
122°F/131°F/140°F/149°F/158°F/167°F.
It’s recommended to setup 55-60°C/131-140°F firstly and
observe the following temperature change after parking, for
better adjusting your setting. Over-temperature operation might
lead to SD card failure or Dash Cam crash.
It’s recommended to have max temperature only up to
65°C/149°F, since SDHC/SDXC memory card may not able to
working/recording under too high temperature for a long time.
Power-PLUS display shows up “OVTP” for indicating power
output cut-off based on Over Temperature. As below:
Notice: Temperature measured by Power-PLUS might be a little
different from Vehicle thermometer due to different
thermo-sensor position. Temperature shown on Power-PLUS is
for reference only. User may setup over-temperature cut-off
gate based on different vehicle environment.
Temperature Setting
Autogoods “130”
130.com.ua