Victor 03 - Output from Calibrator; Caution on Output Terminal Voltage; Output Operation Procedure; Simulating Resistance or RTD Output

5
or not. The setting can be done by themselves. (See section 7 for
reference)
5.
5.
5.
5.
Output
Output
Output
Output
from
from
from
from
Calibrator
Calibrator
Calibrator
Calibrator
The output terminal of the calibrator produces the RTD-simulating
temperature signal or simulating resistance set by the user.
！ C
C
C
C
aution
aution
aution
aution

D o not apply voltage to the output terminal during the operation.
If any improper voltage is applied to the output terminal, it will
cause damage to the internal circuit.
O
O
O
O
utput
utput
utput
utput
Operation
Operation
Operation
Operation
Procedure
Procedure
Procedure
Procedure
5.1
5.1
5.1
5.1
Simulating
Simulating
Simulating
Simulating
Output
Output
Output
Output
from
from
from
from
Resistance
Resistance
Resistance
Resistance
or
or
or
or
RTD
RTD
RTD
RTD
N
N
N
N
ote
ote
ote
ote

R
R
R
R
esistance
esistance
esistance
esistance
simulation:
simulation:
simulation:
simulation:
The calibrator produces the simulated
resistance up to 400 Ω at the output
terminal. The method of simulating
resistance output is to send out an
appropriate voltage ’ VX ’ according to the
exciting current ‘ IX ’ produced by the
calibrated instrument. Because R (set
resistance )= Vx (output voltage) /IX
(exciting current),the calibrated device
must provide an exciting current to the
F
F
F
F
unction
unction
unction
unction
Operation
Operation
Operation
Operation
R
R
R
R
ange
ange
ange
ange
Operation
Operation
Operation
Operation
Display
Display
Display
Display
S
S
S
S
et
et
et
et
Range
Range
Range
Range
OHM
OHM
OHM
OHM
400
Ω
000.0 Ω
000.0 to 400.0 Ω
RTD
RTD
RTD
RTD
Pt100
Pt100

Cu50
000. 0 ℃
000.0 ℃
-200 ℃ to 850 ℃
-50 ℃ to 150 ℃