What does it mean if FAULT and 90 PSI indicators are flashing on my Victor Welding System?
If the FAULT and 90 PSI indicators are flashing, there may be an internal error. Try turning the ON/OFF switch OFF and then back ON again.
General| Brand | Victor |
|---|---|
| Model | CUTMASTER 152 |
| Category | Welding System |
| Language | English |
Covers hazards related to plasma arc cutting, gases, fumes, electric shock, fire, explosion, and noise.
Details the electrical and physical specifications of the power supply unit.
Lists technical specifications for torch configurations and leads.
Instructions for connecting the primary input power, including voltage and phase selection.
Procedures for connecting the gas supply to the unit, including filter installation.
Identifies and explains the functions of the front panel controls and indicators.
Outlines the necessary steps before starting an operating session.
Guides on selecting and changing torch parts based on the type of operation.
Provides detailed instructions for operating the hand torch for cutting.
Details parameters and precautions for performing gouging operations.
Instructions for operating the mechanized torch with CNC or remote control.
Lists and illustrates consumable parts for various cutting operations.
Lists common problems, their possible causes, and recommended solutions.
Provides a guide to diagnose and resolve common operational issues.
Guides on inspecting and replacing consumable parts of the torch.
To Next Page
