3. TRAnSpORT And HAndLinG
3.1 APPLIANCE IDENTIFICATION
When contacting the manufacturer, Victoria Arduino for
any reason, always quote the machine serial number.
The machine is transported on pallets containing several
machines inside boxes secured to the pallet by straps.
Before performing any transport or handling operation,
the operator must:
• wear safety gloves and footwear and overalls with
elasticised ends.
Pallets must be transported using an adequate lifting
mechanism (fork-lift truck type).
CAUTION: COLLISION OR CRUSHING HAZARD
During the entire handling operation, the operator must
make sure no one or nothing is inside the operating
area.
Slowly lift the pallet to about 30 cm from the ground and
move to the loading area. After making sure there are no
obstacles, persons or things, proceed with loading.
Once at destination, always using an adequate lifting
mechanism (eg. fork-lift), after making sure there is no
one or nothing within the unloading area, lower the pallet
to about 30 cm from the ground and transport it to the
storage area.
CAUTION: COLLISION OR CRUSHING HAZARD
Before performing the following operation, make sure the
load is in place and is not likely to fall when the straps
are cut.
The operator, wearing safety gloves and footwear, must
now cut the straps and store the product. To perform this
operation, check the technical characteristics of the prod-
uct to determine the weight of the machine to be stored
and take consequent precautions.
CAUTION: POLLUTION HAZARD
Once the machine has been freed of the pallet or con-
tainer, do not discard these in the environment - pollution
hazard.
To Next Page
Loading...
Need help?
General
