Victoria Arduino MYTHOS 2 Service Manual

3.8 MYTHOS 2
3.5 REMOVAL OF THE FILTER
HOLDER FORK
1 Using a Philips screwdriver remove the side
screws of the fork.
2 With a screwdriver, remove the fixing screw of
the panel.
3.5.1 FILTER HOLDER F
ORK HEIGHT
ADJUSTMENT
A
fter have reinstalled the fork on the machine, if the
size of the filter holder should be larg
er than the set
one, the fork can be adjusted.
Using a crosshead screwdriver, loosen the fastening
screw of the filter holder fork. It is recommended not
to unscrew the screw completely.
Raise or lower the fork in order to adjust it according
to filter holder dimensions.
Once having reached the correct position, make sure
that is properly levelled and tighten the fork fasten-
ing screw.
23
24
25

Victoria Arduino MYTHOS 2 Specifications

General

Brand	Victoria Arduino
Model	MYTHOS 2
Category	Coffee Grinder
Language	English