EasyManua.ls Logo

Victory STAR - Maintenance; Exterior Surface Cleaning; Stainless Steel Filter Care

Victory STAR
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating!
For optimal operation, clean range hood and all ba󰀪e/spacer/lter/grease tunnel/oil container regularly. Regular
care will help preserve the appearance of the range hood.
Cleaning Exterior surfaces:
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent
(e.g. Comet Power Scruv
®
, EZ-O󰀨
®
oven cleaner), or steel wool/scoring pads, which will scratch and damage
the stainless steel surface. For heavier oil use liquid degrease such as “Forumla 409
®
” or “Fantastic
®
” brand
cleaner.
If the hood looks splotchy (stainless steel hood), use a stainless steel cleaner to clean the surface of the
hood. Avoid getting cleaning solution onto or into the control panel. Follow directions of the stainless steel
cleaner. CAUTION: Do not leave on too long as this may cause damage to the hood nish. Use a soft
towel to wipe o󰀨 the cleaning solution, gently rub o󰀨 any stubborn spots. Use a dry soft towel to dry the hood.
After cleaning, you may use non abrasive stainless steel polish such as 3M
®
or ZEP
®
, to polish and bu󰀨 out
the stainless luster and grain. Always scrub lightly, a with clean cotton cloth, and with the grain.
DO NOT allow deposits to accumulate or remain on the hood.
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface and cause
rusting.
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stain-
less steel for extended periods. Many of these compounds contain chemicals, which may be harmful. Rinse
with water after exposure and wipe dry with a clean cloth.
Cleaning Stainless Steel Filters:
IMPORTANT: Drain oil from grease tunnel and lters before oil and residue overow!
The stainless steel lters are intended to lter out residue and grease from cooking. It need not be replaced
on a regular basis, but are required to be kept clean.
Filters should be cleaned after every 30 hours of use.
Stainless steel lters are dishwasher safe. Spray “Formula 409
®
” or equivalent degreasing detergent and
leave to soak if very dirty. Dry the lters and re-install before using the hood.
Replacing Filters:
Should lters wear out due to age and prolonged use, please contact Victory Range Hoods to order
replacement lters.
VICTORY range hoods
| STAR
26
VICTORY range hoods
STAR |
27
MAINTENANCE

Related product manuals