13
.3
Safety
reverse
force
adjustment
Press and hold on "
SET
" button
for
3
seconds
until the LED flashes "1
".
Press "UP"
or
"
DOWN
" button until LED
flashes
"2
",
then press "
SET"
button. It's
now
under force adjustment
mode
.
The
LED displays the
current set force.
Press "UP" button to increase the force and "DOWN" button to
decrease the force.
The
maximum
force
is 9 and the minimum is 1. Press "SET" button to confirm,
then the
opener
returns to standby
mode
.
The
default setting
of
safety reverse force is 3.
13.4
IR
Beam
setting
Press
and
hold on "SET" button
for
3
seconds
until the
LED
flashes
"1". Press "UP"
or
"DOWN"
button until the
LED
flashes "3
",
press
"
SET"
button. It's
now
under IR Beam setting
mode
.
The
LED displays
the
current
setting.
Press "UP" button, the LED displays "1", the IR Beam Function is
available. Press
"DOWN"
button, the LED displays "0" to cancel this function. Press "SET" button to
confirm.
The
opener
returns to standby mode.
The
default setting
of
IR Beam is "0".
Notice:
·Close
the IR
Beam
function when you
don
't use IR Beam sensor.
·We
urge you to
consider
fitting IR
Beams
to
your
new
garage
door
opener
. In many countries these
devices are
compulsory
to assist
in
preventing serious injury
or
property
damage
.
For
your
own
peace
of
mind and the safety
of
others please install this inexpensive safety device.
13.6
Auto<lose
setting
Press and hold on "
SET
" button
for
3
seconds
until the
LED
flashes "1".
Press "UP"
or
"DOWN" to increase
or
decrease
,
adjust
the LED to
flash "4
",
then press "SET" button to enter into
auto<lose
setting, the
LED
displays the current setting.
Press "UP"
or
"DOWN" button to adjust the auto-close time. Press "UP"
button once, the auto-close time will increase
1 minute, the
maximum
time is 9 minutes. Press "
DOWN
" button once, the auto-close time decrease 1 minute,
The
auto<lose
function will be turned
off
when the
LED
displays "0", Press "SET" button to confirm,
the
opener
returns
to
standby
mode
,
The
auto-close function can only be available when the
door
is fully open and the I R
Beam
function is
on
,
The
default setting is "0",
-
12
-
To Next Page
Loading...
