Vicway VR660M - Install the Ir Beams

16.1NSTALL THE IR BEAMS (OPTIONAL ACCESSORy)
NOTE: This accessory must be used for all installations where the closing force as measured
on the bottom ofthe door is over 400 N (40 kgf).
t: ::
~ IR Beams must be installed~
i:= to detect a 1 OOmm high
:: obstacle at any point along ::
:: the floor. ::
II
~ =
~~ams 0.1;;;;;1 ~ ~~am s
ENABLING THE PROTECTOR SYSTEM:(Section 13.4)
• Door may operate unexpectedly, therefore do not allow anything to stay in the path of the
door.
17.1NSTALL UNIVERSAL RECEIVER(OPTIONAL ACCESSORy)
Install the line wall button amI universal receiver (Refer Section 15)
- 15 -