7.
THE RELEASE
HANDLE
& CORD
• Thread one end of the rope through the hole
in
the
top of the red release handle
so
that "NOTICE"
reads right side
up
as shown.
Release
Cable
Overhand
Kno~
• Secure with
an
overhand knot at leasl
25
mm
from
the end of the
rope
to prevent slipping.
• Thread the olher end of the rope through the loop
of the manual release cable.
• Adjust rope length
so
the handle (when installed)
will
be
no higher than 1.8 m above the floor. Secure with
an
overhand
knot.
Overhand
Knot
1 2
3
4
NOTE: Final
adjustment
of
handle height
should
be
completed
after the
opener
is
installed
.
If It
is
necessary to cut the rope, heat seal the cut end to prevent unravelling.
8.0PERATING THE
MANUAL
RELEASE
To disengage
the
opener
Pull the release
cord
down
firmly,
To re-engage
the
opener
Pull the release
cord
down
firmly,
NOTE:
Disable
all
locks
and
remove
any
ropes
connected
to
the
garage
door.
Take
care
when
operating
the
manual
release
as
an
open
door
may
fall
rapidly
due
to
weak
or
broken
springs,
or
being
out
of
balance.
- 8 -
Pull j
Down
FIRMLY
To Next Page
Loading...
