14. TESTING THE
SAFETY
REVERSE SYSTEM
The
safety
reverse
system
test
is
important.
The
garage
door
must
reverse
on
contact
with
a 40
mm
obstacle
laid
flat
on
the
floor.
Failure
to
properly
adjust
the
opener
may
result
in
serious
personal
injury
from
a
closing
garage
door.
~/--------------~/~
40mm!
~
Operate the door
in
the down
direction. The door must reverse
upon contact with the obstacle. If the
door stops on the obstacle, remove
obstacle and repeat
limit and force
setting (refer section
13
.
3)
.
40mm Test O
bs
tacle
Repeat
test
of
the
safety reverse
system.
1S.FIXING WARNING
LABELS
Once you have completed your installation and
successfully carried out the safety reverse
system test (outlined above), install the warning
labels provided with your opener
as
shown.
The WARNING label must
be
installed in a
prominent place near any
fi
xed control.
Any fixed wall control or wireless door control
must be mounted at a height
of
no less than 1.5
m
out
of
the
reach
of
children
.
Read the safety instructions (page 1) for further
details concerning safety.
Handle
should
be
less
than
1.8m
-----m
Wall
control
,
or
wireless
push
button
no
188s
than 1.5m
Ground
level
E
.,
-
14
-
E
.,
To Next Page
Loading...
