How to increase speech volume on Videx Intercom System?
If you're experiencing low speech volume on your Videx Intercom System, the volume trimmers of the door station may require adjustment. Adjust the trimmers until the required volume is reached.
Why is the intercommunicating call not working on my Videx 6256 Intercom System?
If the intercommunicating call feature is not working on your Videx Intercom System, it could be because the ”Key” button was pressed a number of times different from the videophone address value. To solve this, check the address of the videophone you are calling and try again, pressing the “Key” button the correct number of times.
What to do if local call does not work on Videx Intercom System?
If local calls are not working on your Videx Intercom System, it could be due to a wrong connection or a broken call button. To resolve this, check the connection or replace the button.
How to fix Videx 6256 when door station doesn't call extension?
If your Videx Intercom System's door station isn't calling the extension and the bell LED is on for 2 seconds, the issue could stem from several causes: * Incorrect wiring between the door station and videophone: Check the 6 common wire connections, especially wire “1” (speech line/data). * Insufficient cable size: Increase cable size or double up using two wires for each connection. * Incorrectly programmed videophone address: Verify the videophone address on the dip-switches. * Address change without system reboot: Power down the system and then power it up again to detect the new videophone address.
What to do if Videx Intercom System external call works but communication fails?
If your Videx Intercom System's external call works but the communication fails when answered, the cause may be that the cable size is too small. The suggested solution is to increase the cable size or double up using two wires for each signal.
How to fix low volume of speech on Videx 6256 Intercom System?
If you are experiencing low volume of speech on your Videx Intercom System, it could be that the volume trimmers of the door station require adjustment. Adjust the trimmers until the required volume is reached.
Why can't I open the door on my Videx 6256 Intercom System even though the key LED is on?
If you cannot open the door during a conversation on your Videx Intercom System, but the key LED on the door station activates, there could be a few reasons: * The J2 jumper might be in the wrong position. * The electric lock wires might be unconnected or shorted. * The electric lock type might be incorrect. To resolve this: 1. Check the J2 position on the door station. 2. Check the electric lock wire connections. 3. Ensure the electric lock type (AC or DC) is suitable for the chosen J2 position.
Why is speech only working from outside to inside on my Videx Intercom System?
If you can only hear speech from outside to inside on your Videx Intercom System, it is possible that wire “2” is broken or shorted. You should check the connection of wire “2”.
How to fix bad video quality on Videx Intercom System?
If the video shown on the monitor of your Videx Intercom System is of bad quality and the image is distorted or double, it could be due to several reasons: * V1, V2 signals unconnected, reversed, or shorted. * The switches of the two-way dip-switch are not both in the ON position. * V1, V2 of the last Art. 316N (if present) not closed with a 75 Ohm resistor. To solve this: * Check that the wires are not broken or shorted. * Set both switches to the ON position. * Use 2x 75 Ohm resistors to connect V1 & V2 to 0V.
How to fix Videx Intercom System when it's not possible to open the door during conversation?
If you can't open the door during a conversation on your Videx Intercom System, the cable size might be too small. Increasing the cable size or doubling up using two wires for each signal may resolve this issue.
Details the 3.5" Hi-Res LCD, 4 buttons, and programmable functions.
Explains the operation of service, camera recall, door open, and privacy buttons.
Explains the Door Open LED and Privacy ON/OFF LED indicators.
Details controls like SW1 dip-switch, brightness, hue, and contrast trimmers.
Covers dip-switch settings, terminal signals, technical specs, and memory board info.
Step-by-step guide to safely remove and open the videophone cover.
Instructions for marking, drilling, wiring, and fixing the base to the wall.
Covers connecting terminals, testing the system, and closing the unit.
General| Brand | Videx |
|---|---|
| Model | 6256 |
| Category | Intercom System |
| Language | English |
To Next Page
