Viessmann B2HAH13 - Page 25

25
5461 885 - 04
Vitodens 200-W B2HA/B2HB, 222-F B2TA/B2TB Operating
Setting the Time Program for DHW Heating (continued)
Heating
Deleting a time phase for DHW recirculation pump
Set the time for the end point to the same time that was
set for the start point. The display shows the selected
time phase “- - : - -”.
Stopping DHW heating
You do not want to have DHW or heat the rooms.
For the heating circuit displayed in the header
Standard menu:
1.
for the heating program “Standby mode”
(frost protection monitoring)
2. OK to confirm
For the other heating circuits
Extended menu:
1.
2. Select the heating circuit if necessary (see page 16)
3. “Heating”
4. “Heating program”
5. “Standby mode” (frost protection monitoring)
You do not want DHW, but do want to heat the rooms.
Extended menu:
1.
2. Select the heating circuit if necessary (see page 16)
3. “Heating”
4. “Heating program”
5. “Heating and DHW”
6. until the menu is displayed
7. “DHW”
8. “Set DHW temperature”
9. Select 50°F (10°C)