Viessmann Vitorond 100 - Page 17

Set-up
17
Insulation Installation
3. If installing Vitotronic control:
Run the plug-in connector cable of
the Vitotronic control down behind
the front panel of the boiler and out
through the bottom.
4. Install support brackets
.
5. Position left side panel onto support
brackets .
6. Line up bottom tab of side panel with
notch in casting leg of rear section.
7. Once side panel is in place, bend
down tab using pliers as shown.
5671 044 v1.0
A
41
2x
M10
SW15
5.
3.
6.
7.
4.
Fig. 9