50
You can restore the factory settings of all modified val-
ues for every heating/cooling circuit, DHW heating and
other system settings separately.
1. Extended menu:
2. "Settings"
3. "Standard setting"
4. Select the required system setting, e.g. "DHW".
System setting Settings and values that are reset
"System"
■
Time program for the heating water buffer cylinder
■
Electric booster heater is blocked for central heating.
■
Time program for electric booster heater
■
Time program for reduced noise operation
"DHW"
■
Standard DHW temperature
■
Higher DHW temperature
■
Time program for DHW heating
■
Time program for DHW circulation pump
■
Electric booster heater is enabled for DHW heating.
■
Start and stop optimisation are switched off.
"Electr booster heater"
■
Electric booster heater is blocked for central heating.
■
Time program for electric booster heater
"Heating circuit 1"
"Heating circuit 2"
"Heating circuit 3"
■
Standard room temperature
■
Reduced room temperature
■
Time program for central heating
■
Heating curve slope and level
■
Comfort and energy saving functions ("Party mode", "Economy
mode" and "Holiday program") are stopped.
Note
If names have been given to the heating/cooling circuits, these are re-
tained: see chapter "Setting names for heating/cooling circuits".
"Cooling"
■
Standard room temperature
■
Cooling curve slope and level
■
Active cooling mode is blocked.
"Ventilation"
■
Time program for ventilation
■
Comfort and energy saving functions ("Intensive operation", "Econ-
omy mode" and "Holiday program") are stopped.
"Photovoltaics"
■
Utilisation of power generated on site is switched off for all compo-
nents.
"Smart Grid"
■
No function is enabled for utilising excess power.
Further adjustments
Restoring factory settings
5790940
To Next Page