33
Setting the standard DHW temperature
Factory setting: 50 °C
1. Extended menu:
2. "DHW"
3. "Set DHW temperature"
4. Set the required value.
Setting the higher DHW temperature
Factory setting: 60 °C
The DHW will be heated to the higher DHW tempera-
ture under the following circumstances:
■
In the time program for DHW heating, you have set a
time phase for the "Temp. 2" operating status: see
page 34.
■
You have activated once-only DHW heating: see
page 35.
■
You have activated manual mode: see page 56.
1. Extended menu:
2. "DHW"
3. "Set DHW temperature 2"
4. Set the required value.
Note
Where necessary, enable the electric booster heater in
order to achieve the required DHW temperature: see
page 37.
Operating program
Further information can be found in chapter
"Terminology" in the appendix.
Setting the operating program for DHW heating
For the preferred heating/cooling circuit
1. Standard menu:
/ for the operating program:
e.g. "Only DHW"
2. OK to confirm
For further possible operating programs: see page 19.
For all heating/cooling circuits
1. Extended menu:
2. "Heating" or "Heating/cooling"
3. If applicable, use / to select the required heating/
cooling circuit
4. "Operating program"
5. E.g. "Only DHW".
For further possible operating programs: see page 19.
Time program
Further information can be found in chapter
"Terminology" in the appendix.
DHW heating
DHW temperatures
5790940
To Next Page
Loading...
