9
Your heating system is delivered from
the factory in standby mode, i.e. frost
protection is active.
Your heating contractor can make fur-
ther settings for you during commis-
sioning.
You can change the settings at any
time to suit your individual require-
ments.
Power failure
All settings are saved if there is a
power failure.
Energy saving tips
Central heating
■ Room temperature:
Never overheat your rooms. Every
degree of room temperature reduc-
tion saves up to 6 % on your heating
bills.
If possible, set your room tempera-
ture no higher than 20 °C (see
page 18).
■ Ventilation:
For venting/airing, open the windows
fully for a brief time. During this time,
close the thermostatic valves (if no
mechanical ventilation system is
installed).
■ Roller shutters:
Close roller shutters (where installed)
at dusk.
■ Thermostatic valves:
Ensure that thermostatic valves are
properly adjusted.
■ Radiators:
Never cover radiators or thermostatic
valves.
DHW heating
■ DHW temperature:
Do not set your DHW temperature
too high (see page 28).
■ Hot water consumption:
Consider showering instead of run-
ning a bath. A shower generally uses
less energy than a full bath.
Introductory information
Your system is preset
5837147
To Next Page
Loading...
Need help?
General