VIETA VMD95LS - Connecting the Antenna; Connecting Control Cable

6
Connecting the AntennaConnecting the Antenna
Connecting the AntennaConnecting the Antenna
Connecting the Antenna
1. Using the supplied wire Antenna.
2. Using the coaxial type connector .
A 75Ohm antenna with coaxial type connector should be connected to the FM 75 ohm coaxial
terminal.
3. If reception is poor, connect the outside antenna.
Note:Note:
Note:Note:
Note: Before attaching a 75 ohm coaxial lead (the kind with a round wire going to an outside
antenna), disconnect the supplied FM wire antenna.
Caution:Caution:
Caution:Caution:
Caution: To avoid noise, keep antennas away from the system, the connecting cord and the AC
cord.
Connecting Control CableConnecting Control Cable
Connecting Control CableConnecting Control Cable
Connecting Control Cable
Connect signal line between the main set and the sub-woofer back board.
-/0
Terminal board for Sub-Woofer
Terminal board for Main Set