ViewSonic PA700S - Advanced Projector Options

58
 

Direct Power On
Automacally power on the projector when AC power
is supplied, without pressing the  buon on the
projector or the remote control.
Auto Power O
A countdown mer will start when there is no signal being
sent to the projector. The projector will automacally power
o when the countdown has nished (in minutes).
Power Mode (Standby)
 

Normal standby (> 0.5W) with VGA
available.

Reduce power use (< 0.5W) with no
VGA available.
Signal Power On
Automacally power on the projector when a signal is
detected from the input source, without pressing the 
buon on the projector or on the remote control.
 The projector will not power on automacally by
HDMI if there is only one HDMI cable connected.
Exit
Exit the Advanced menu.

Lamp Hour
Displays the lamp hours of the current lamp.
Lamp Reminder
Show or to hide a warning message when the “change lamp
message” is displayed.
Brightness Mode
 

Highest brightness and power
consumpon.

Dim the light output, lowering
power consumpon.

Automacally adjust the picture
brightness in order to give opmum
contrast performance.
Lamp Reset
Resets the Lamp Hour counter. Should be used aer
replacing the lamp.
Exit
Exit Lamp Sengs.