ViewSonic PJ1158 - Before Using the Network Functions

Network Functions
Before using the network functions…
To use the network functions of this projector, the projector must be congured to
suit your network. Consult with your network administrator before connecting the
projector to your network. Incorrect network conguration of this projector may
cause problems on your network.
Connect to the Gateway (The router/PC that forwards trafc to a destination
outside of the subnet of the transmitting device) from the network terminal on the
projector using a CAT-5 cable and congure the following settings.
If using a network with DHCP enabled:
The projector’s network settings can be congured automatically. when [DHCP]
on the network menu is set to [TURN ON]. Please refer to DHCP in network
menu. If a xed / static IP address is required, please congure your projector ac-
cording to the steps in the following section.
If using a network system that does not have DHCP enabled or if
using a xed IP address on a network system equipped with DHCP
enabled:
Congure the following settings on the network menu.
1.
[DHCP]: Disable DHCP (Set [DHCP] to [TURN OFF]).
2.
[IP ADDRESS]: Enter an appropriate IP address for the projector to connect
to your network.
3.
[SUBNET MASK]: Enter an appropriate SUBNETMASK for the projector to
connect to your network.
4.
[DEFAULT GATEWAY]: Enter an appropriate Gateway (the router/PC that
forwards trafc to a destination outside of the subnet of the transmitting de-
vice) address for the projector to connect to your network.
57ViewSonic PJ1158