ViewSonic PJ1158 - Communication Port; E-Shot(Still Image Transfer) Display

e-SHOT (Still Image Transfer) Display
e-SHOT (Still Image Transfer) Display
The projector can display a still image that is transferred via the network.
Communication Port
The following port is used for e-SHOT.
TCP #9716
e-SHOT (Still Image Transfer) Settings
Congure the following items from a web browser when e-SHOT is used.
Example: If the IP address of the projector is set to 192.168.1.10:
• e-SHOT is not available via communication ports which are used for
the command control (TCP #23 and TCP #9715).
NOTE
1) Enter
[https://192.168.1.10] into the address bar of the web browser.
2) Enter the Administrator ID and Password and
click [Logon].
3) Click [Port settings] on the main menu.
4) Click the [Enable] check box to open the [Im-
age Transfer Port (Port: 9716)]. Click the
[Enable] check box for the [Authentication]
setting when authentication is required, other-
wise clear the check box.
5) Click the [Apply] button to save the settings.
86ViewSonic PJ1158