e-SHOT(Still Image Transfer) Display
e-SHOT (Still Image Transfer) Settings (Continued)
When the authentication setting is enabled, the following settings are required.
6) Click
[Security Settings] on the main menu.
7) Select [Network Control] and enter the desired authentication password. *
see Note1
8) Click the [Apply] button to save the settings. * see Note2
• The Authentication Password will be the same for [Network Control
Port1 (Port: 23)], [Network Control Port2 (Port: 9715)], and [Image Transfer
Port (Port: 9716)].
NOTE1
• The new conguration settings are activated after restarting the
network. Restart the network connection when any conguration settings are
changed. The network connection can be restarted using [Network Restart] on
the main menu.
NOTE2
e-SHOT (Still Image Transfer) Transmission
e-SHOT transmission requires an exclusive application for your PC. You can
download it from the ViewSonic web site. Refer to the manual for the application
for instructions.
87ViewSonic PJ1158
To Next Page
Loading...
