34
SYSTEM SETTING: ADVANCED
High Altitude Mode
Use this function to allow the fans operates at full speed continuously to achieve
proper high altitude cooling of the projector.
DCR
DCR (Dynamic Contrast Ratio): Enable DCR will further enhance contrast ratio by
darkening the black scenes. Disable DCR will resume to normal contrast
performance. DCR will impact lamp life and system noise performance.
Closed Caption
Enable or disable closed captions by selecting CC1 (closed caption1, the most
common channel), CC2, CC3, CC4, T1, T2 or OFF.
Lamp Settings
Lamp Mode
Sets the Lamp Mode.
• Normal: 100% lamp power
• Economic: 80% lamp power
• Dynamic: 30~100% lamp power based on signal
• Sleep Mode: 30% lamp power
Reset Lamp Hours
Reset the lamp Hour to 0 hours.
Lamp Hours
Display the lamp’s elapsed operating time (in hours).
Filter Settings (Optional)
Filter Mode
Use this function to activate filter mode after the projector is installed an optional filter
cover.
Reset Filter Hours
Reset the filter Hour to 0 hours.
Filter Hours
Display the filter’s elapsed operating time (in hours).
Remote Control Code
See "Remote control code" on page 10 for details.
Advanced
Security Settings
• Change Password: Allows you to set or change the password.
To Next Page
Loading...
