ViewSonic PJL6243 - Rear Terminal

9ViewSonic PJL6243
9
⑦
(MIC)-
Part Names and Functions
RearTerminal
② ③①
⑥
⑤
⑧
④
④ VIDEO IN
Connect the composite video output signal
to this jack (p.15).
② COMPUTERIN1/S-VIDEOIN/
COMPONENTIN
Connect output signal from a computer,
component video output, RGB scart 21-
pin video output or S-video output to this
terminal. (pp.14-16).
⑥ AUDIOOUT(VARIABLE)
Connect an external audio amplifier to this
jack (pp.14-16).
This terminal outputs sound from AUDIO IN
terminal.
Never plug headphones into this jack.
⑤ LANConnectionTerminal
Connect the LAN cable (refer to the User
Guide of “Network Set-up and Operation”).
① CONTROLPORT
When the projector is controlled by a
computer, connect to this jack with serial
control cable.
③ COMPUTERIN2/MONITOROUT
– Connect analog RGB output signal from a
computer to this terminal (p.14).
– This terminal can be used to output the
incoming analog RGB and Component
signal from COMPUTER IN 1 /S-VIDEO
IN /COMPONENT IN terminal to the other
monitor (pp.14,16).
⑦
⑦ AUDIOIN(PC/MIC)
Connect the audio output signal from
computer or video equipment connected to
② and ③ to this jack. Or connect the MIC to
this jack. (pp.14-16).
⑧ AUDIOIN(L/R)
Connect the audio output signal from video
equipment connected to ④ to this jack. For
a mono audio signal (a single audio jack),
connect it to L(MONO) jack. (p.15).
Note: When using AUDIO IN(PC/MIC)
terminal as MIC input, these terminals can
be used for PC audio input.