ViewSonic PJL6243 - Computer Input; Input Source Selection (Rgb: Computer 1;Computer 2)

27ViewSonic PJL6243
27
Choose either Computer1(RGB)or Computer2(RGB) by pressing the COMPUTER 1 or COMPUTER 2 button on
the remote control.
Before using these buttons, correct input source should be selected through Menu operation as described below.
1
Input Menu
2
3
Note:
When the Input Search function is set to On 1
or On 2 in the Auto setup function, the input
signal will be searched automatically (p.45).
Computer
1
Remote Control
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select Input
and then press the Point ► or the SELECT button.
Use the Point ▲▼ buttons to select Computer 1.
When Computer 1 is selected, press the Point
► button to access the submenu items. Use the
Point ▲▼ buttons to select the RGB input source
and then press the SELECT button.
COMPUTER1button
Computer1(RGB)
Computer1(Scart)
InputSourceSelection(RGB:Computer1/Computer2)
Computer2(RGB)
COMPUTER2button
Direct Operation
Menu Operation
Computer Input
OR
Use the Point ▲▼ buttons to select Computer 2
and then press the SELECT button.