22ViewSonic PJL6243
22
Basic Operation
Menu Bar
For detailed functions of each menu, see “Menu Tree” on pages 66-67.
Main Menu Sub-Menu
③ Image select
Used to select an image mode from among Dynamic, Standard, Real, Cinema, Blackboard(Green),
Colorboard and Image 1-4. (pp.32, 39)
④
Image adjust
For computer source, used to adjust computer image [Contrast, Brightness, Iris, Color temp., White
balance(R/G/B), Sharpness, Gamma,
Reset and Store
] (p.33).
For Video source, used to adjust picture image [Contrast, Brightness, Color, Tint, Iris, Color temp.,
Whitebalance(R/G/B), Sharpness, Gamma, Noise reduction, Progressive,
Reset and Store
] (pp.40-
41).
② PC adjust
Select Auto PC adj., Fine sync, Totaldots, Horizontal, Vertical, Currentmode, Clamp, Display area-
H and Display area-V to adjust the parameters to match with the PC input signal format (pp.29-31).
⑤
Screen
For computer source, used to adjust size of the image [
Normal,
Full,
Wide(16:9), Zoom, True,
Custom,
Custom adj., Digitalzoom+/– , Keystone, Ceiling, Rear and Reset] (pp.34-35).
For Video source, used to set size of image [Normal,
Full,
Wide(16:9), Zoom, Custom,
Custom adj.,
Keystone, Ceiling, Rear and Reset
] (pp.42-43).
① Input
Used to select an input source from Computer 1, Computer 2 or Video (pp.27, 36-37).
⑥ Sound
Used to adjust the volume or mute the sound or set configurations to the MIC functions (p.24).
⑧ Information
Display the input source information: Input , H-sync freq., V-sync freq., Screen, Language, Lamp
status, Lamp counter , Power management, Keylock, PIN code lock and Remote control. (p.57)
⑩ Guide
The key operation is displayed.
⑦
Setting
Used to set the projector’s operating configurations (pp.44-56).
⑨ Network
See User Guide of “Network Set-up and Operation”.
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
To Next Page
Loading...
