ViewSonic PX700HDH - Remote Control Effective Range; Replacing the Remote Control Batteries

13
Remote Control Effective Range
To ensure proper function of the remote control
follow the steps below:
1. The remote control must be held at an angle
within 30° perpendicular to the projector’s IR
remote control sensor(s).
2. The distance between the remote control and
the sensor(s) should not exceed 8 m (26 ft.)
NOTE:
Refer to the illustration for the location of
the infrared (IR) remote control sensor(s).
Approx. 30°
Replacing the Remote Control Batteries
1. Remove the baery cover from the rear of the remote control by pressing the
nger grip and sliding it down.
2. Remove any exisng baeries (if necessary) and install two AAA baeries.
NOTE: Observe the battery’s polarities as indicated.
3. Replace the baery cover by aligning it with the base and pushing it back into
posion.
NOTE:
• Avoid leaving the remote control and baeries in excessive heat or a humid
environment.
• Replace only with the same or equivalent type recommended by the baery
manufacturer.
• Dispose of the used baeries according to the manufacturer’s instrucons and
local environment regulaons for your region.
• Never throw the baeries into a re. There may be danger of an explosion.
• If the baeries are drained or if you will not be using the remote control for an
extended period of me, remove the baeries to avoid damage to the remote
control.