ViewSonic X11-4K - Effective Range and Battery Replacement

14
Remote Control - Eecve Range
To ensure proper funcon of the remote control
follow the steps below:
1. The remote control must be held at an angle
within 30° perpendicular to the projector’s IR
remote control sensor(s).
2. The distance between the remote control and
the sensor(s) should not exceed 8 m (26 .)
NOTE: Refer to the illustraon for the locaon
of the infrared (IR) remote control
sensor(s).
AUDIO
OUT
S/PDIF AUDIO
IN
HDMI 1
HDCP2.2
HDMI 2
HDCP2.2
ARC
USB C
MICRO SD
LAN
USB 1 (2.0)
5V/1.5A
USB 2 (2.0)
5V/1.5A
Approx. 30°
Approx. 30°
Remote Control - Replacing the Baeries
1. Remove the baery cover from the rear of the remote control by pressing the
nger grip and sliding it down.
2. Remove any exisng baeries (if necessary) and install two AAA baeries.
NOTE: Observe the baery’s polaries as indicated.
3. Replace the baery cover by aligning it with the base and pushing it back into
posion.
NOTE:
• Avoid leaving the remote control and baeries in excessive heat or a humid
environment.
• Replace only with the same or equivalent type recommended by the
baery manufacturer.
• If the baeries are drained or if you will not be using the remote control for
an extended period of me, remove the baeries to avoid damage to the
remote control.
• Dispose of the used baeries according to the manufacturer’s instrucons
and local environment regulaons for your region.