ViewSonic X11-4K - Making Connections; Connecting to Power

18
Making Connecons
This section guides you on how to connect the projector with other equipment.
Connecng to Power
1. Connect the power cord to the AC IN jack at the rear of the projector.
2. Plug the power cord into a power outlet.
NOTE: When installing the projector, incorporate a readily accessible disconnect
device in the xed wiring, or connect the power plug to an easily
accessible outlet near the unit. If a fault should occur during operaon of
the projector, use the disconnect device to switch o the power supply,
or disconnect the power plug.