Viking FDSB5481 - Upper Grille Assembly; Control Panel

Disassembly
©2012 Viking Preferred Service 13
WARNING!
Screws
Securing tab
Securing tab
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless
test procedures require power to be connected. Ensure all ground wires are connected before certifying unit as
repaired and/or operational.
Removal of the upper grille assembly allows
access to the control assembly.
1. To remove the upper grille assembly, slide
out the middle air louver.
Middle Air Louver
2. With the middle grille louver removed,
remove the (2) 1/4" hex screws securing
the grille assembly.
Remove 1/4" screw
on each side
3. Remove the grille assembly
The control panel has an overlay switch
attached to it that allows user input to the
control boards.
1. To access the control panel, remove the
upper air grill assembly (see Upper Grill
Removal section), remove (2) screws
securing the control panel.
Upper Grille Assembly
Control Panel
2. Pull control panel from securing tabs.
3. Lower the control panel. Take caution with
the ribbon cable to prevent damage.