© 2011 Viking Preferred Service
32
Water Dispenser
To access the water dispenser:
1. Insert a screwdriver blade and carefully remove
the top cover of the dispenser.
2. Remove hex head screw to release dispenser
from cabinet.
3. Disconnect wiring and water line from dispenser
assembly.
4. Replace or repair as necessary.
5. Reverse procedure to reinstall.
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Service Diagnostics and Procedures–Disassembly
Water Dispenser
Screw
Water Line
Screwdriver
Blade
To Next Page
Loading...
