Viking VGSO100 - Door Service Procedures; Oven Door Removal; Oven Door Reinstallation

Service Procedures
14 ©2012 Viking Preferred Service
Door Removal
In order to remove the oven doors, you will
rst need to locate the hinge locking pins that
were supplied with the packing material. THE
PINS MUST BE IN PLACE in order to remove
the door without damaging the oven door or
frame.
Open door completely and place pin into the
pin hole.
Using a Phillips head screwdriver, remove the
left and right hinge trim and place to the side.
With the pins in place, close the door until
pins stop door.
Lift the door up and then towards you. The
door will come off with the left and right
locking pins holding the door hinges in place.
Place the door on a protective surface.
Door Reinstallation
In order to reinstall the door, grasp rmly from
each side and align the door hinges into the
receivers on both sides of the oven frame.
Allow the hinges to gently drop into place.
Open door to the full 90˚ position and remove
the door pins. Reinstall the hinge trim. Make
sure to return the door pins to a safe place
should the door need to be removed in the
future.