52 - ENGLISH
If the LED blinks red it means the
MASTER smart card was not recognised.
Remove the incorrect smart card and
insert the correct one.
7.1.3
Wait for the LED to turn red (after about
15 seconds), then insert the MASTER
smart card to enable the procedure.
If the MASTER smart card is not inserted
within 15 seconds, the LED turns off and
the device exits the procedure.
MASTER
card
MASTER
card
7.1.2
Press the front button again. The LED
turns yellow.
7.1.1
Press the front button.
The LED blinks in the sequence red-off-
green.
7.1
Associating a relay
7.
Associating a relay with the reader
This procedure associates a relay with the reader.
The associated relay will then be triggered only if the reader
recognises the smart card.