Vimar Eikon - Duplicating SLAVE Smart Cards

ENGLISH - 31
5.3.15
Remove the smart card.
The LED turns green again.
5.3.16
To exit the procedure, place dip-switch
1 in the OFF position. The LED switches
off.
1 2 3
4 5 6
7 8
ON
5.4 Duplicating
SLAVE
smart cards
This procedure can be used to make copies of SLAVE
smart cards at any time.
Note: When duplicating smart cards that are enabled for
several readers/programmers, the procedure must be
repeated on each reader/programmer.
5.4.1
Press the front button.
The LED blinks in the sequence red-off-
green.
5.4.2
Press the front button again. The LED
turns yellow.