Vimar Eikon - Page 95

ENGLISH - 29
5.3.4
The LED switches off to signal that the
smart card code has been copied, and
the reader synchronised.
5.3.5
Remove the smart card.
The LED turns green again.
5.3.6
To exit the procedure, place dip-switch 1
in the OFF position.
The LED switches off.
1 2 3
4 5 6
7 8
ON
1 2 3
4 5 6
7 8
ON
5.3.8
Press the front button within 15 sec-
onds. The LED turns red.
Warning!
If the button is not pressed within 15 sec-
onds, the LED turns red and the system
switches to the “Reprogram reader codes
and smart cards” procedure.
To exit the procedure, place dip-switch 1
in the OFF position.
Repeat the procedure from step 5.3.7.
5.3.7
Place dip-switch 1, on the reader being
synchronised, in the ON position.
The LED lights up yellow.
Synchronising an already-initialised reader