18
SW24.W
EN
RAD
Remote control management
PP
Saving a button as step-step
oooo Waiting for code
1001 Remote control 1 saved as step-step
1055 Remote control 55 saved as step-step
OPEN
Saving a button as open
oooo Waiting for code
2001 Remote control 1 saved as open
2055 Remote control 55 saved as open
PED
Saving a button as pedestrian
oooo Waiting for code
3001 Remote control 1 saved as pedestrian
3055 Remote control 55 saved as pedestrian
RAU
Saving a button as Auxiliary Radio Output activation
oooo Waiting for code
4001 Remote control 1 saved as Auxiliary Radio Output
4055 Remote control 55 saved as Auxiliary Radio Output
CLS
Saving a button as close
oooo Waiting for code
5001 Remote control 1 saved as close
5055 Remote control 55 saved as close
STP
Saving a button as stop
oooo Waiting for code
6001 Remote control 1 saved as stop
6055 Remote control 55 saved as stop
LCO
Saving a button as Courtesy light on
oooo Waiting for code
7001 Remote control 1 saved as Courtesy light on
7055 Remote control 55 saved as Courtesy light on
CTRL
Control of remote control memory position
oooo Waiting for code
5001 Remote control button 1 saved as close
7099 Remote control button 99 saved as Courtesy light on
-030 Remote control button 30 not in memory
---- Remote control not in memory
RE
Remote control programming Default 1
OFF Remote programming of remote controls o
1
Remote programming of remote controls on:
used to programme remote controls from a remote control already in the memory, using the
following procedure:
- press buttons 1 and 2 on the remote control already in the memory at the same time
- press the button on the remote control already in the memory to copy on the new remote
control
- press the button on the new remote control on which to copy the button just pressed on
the remote control already in the memory
Note: the button on the new remote control just saved inherits the function assigned to the
button on the remote control already in the memory
ERSA
Total receiver memory deletion
Press OK for 5 s
oooo Signals the deletion of the receiver memory on the display
ERS1
Deletion of single remote control from its position in the memory
X Use buttons ▲▼ to select the number of the remote control to delete
Press OK to conrm
ERSR
Deletion of single remote control from the remote control code
oooo Waiting for code
Deleting remote control
To Next Page
Loading...
