◆ MOTION : This can detect the movement of a subject and you can see the moving image of
the subject on the monitor when the camera detects it. In the state of Motion Detection On,
a new submenu below appears when you press the Set button.
◆ PRIVACY : This is used to hide certain areas on the monitor. You can designate each
different 8 area.
The size of a designated area can be adjusted. The color of a privacy area can be selected
15colors.
When you select the return, the setting values in this function menu are saved, then get out
of this menu.
◆ DEFECT : You can eliminate white spots (defect) up to max.512 points.
- Area : Youcan designate areas up to a maximum of 4.
- AREA DISPLAY : After the selection of an area, the area screen should be activated On to
use the motion detection function in a designated area. When this is activated, you can
select the location of area, a size of area coverage.
- VALUE (Sensitivity) : The higher the setting value is, the higher the sensitivity gets, even
though the movement of a subject.
- Motion View : If the camera detects a motion, the sentence like “Motion Detection” appears
on the monitor.
- Return : Save the setting value of this menu, return to the SPECIAL menu.
PRIVACY
DEFECT
AREA
AREA DISPLAY
COLOR
TRANSPAR
RETURN
SENSE UP
DIFF
THRESHOLD
START
RETURN
4
ON
8
3
RET
x32
1
2
RET
MOTION
AREA
AREA DISPLAY
VALUE
MOTION VIEW
RETURN
1
ON
80
OFF
RET
IIIIIIIIIIIIIIII IIII|
IIIIIIIIIIIIIIIIIIII|
IIIIIIIIIIIIIIIIIIII|
IIIIIIIIIIIIIIIIIIII|
IIIIII IIIIIIIIIIIIII|
22
CCTV
EN
To Next Page
Loading...
