14
7511001
9.3) Troubleshooting
Skill level required: O - trained operator
Problem Possible causes Possible remedies
The platform does not move Emergency STOP pressed Turn the button
in either direction clockwise through 45°
Overload cutout tripped Press the reset button
Differential circuit-breaker Call a VIMEC authorised
tripped technician
Gates and locks Close the gates properly
Safety gear switch Replace drive bushing
The platform does not respond Obstacles underneath the Remove the obstacles
to the “down” command platform
The platform does not respond Gates and locks Close the gates properly
to the “fl oor call” command
The platform does not respond Platform fl ap failing to rise
to the “up” command
10) ELECTRICAL WIRING DIAGRAMS
The electrical wiring diagrams are in the folder supplied
with the lift.
11) VIBRATION – AIRBORNE NOISE LEVELS
a) Vibration
The lift causes vibration in the passenger’s body with
the following characteristics:
- low frequency, very low acceleration;
- short exposure cycles for the transported person.
This parameter is therefore insignifi cant for safety
purposes.
b) Airborne noise: less than 70 dBA
12) GUIDANCE ON DISPOSING OF LIFT PARTS
AND SUBSTANCES
a) Disposing of rubber, plastics and packaging
material.
Place in clean containers and consign to disposal cen-
tres authorised under the relevant regulations.
7512001
To Next Page
Loading...
Need help?
General
