What to do if the Vimec Lifting Systems shows a low battery?
If your Vimec Lifting Systems indicates a low battery, it will move slowly to the nearest intermediate floor or parking position and stop to recharge. Check the battery. If the alarm continues, replace the battery.
Why does the Main Relay Error occur in vimec V59 Lifting Systems?
The Main Relay Error in Vimec Lifting Systems happens because the general relay contact remains closed. This error is detected when contact closure is requested and cannot be restored. To resolve this, ensure that the contacts open when there is no power.
What to do if the Emergency switch SB0 activation is on in vimec V59 Lifting Systems?
Check whether the emergency button is pressed. Also check the sheath.
What to do if Rear boards SQCARTER intervention is on in vimec V59?
Check if the housing is pressed and also check the sheath.
What to do if Over-run SQ4 microswitch activation is on in vimec V59 Lifting Systems?
Check if the microswitch is pressed and also check the sheath.
What to do if Safety gear SQ2 microswitch activation is on in vimec V59 Lifting Systems?
Check if the microswitch is pressed and also check the sheath.
How to fix Inclinometer tilt activation in vimec V59 Lifting Systems?
Check to see if the machine is parallel to the floor and also check the sheath.
How to resolve Hall Sensor Error in Vimec Lifting Systems?
To resolve a Hall Sensor Error in Vimec Lifting Systems, replace the motor.
Check machine status, inputs, and general parameters like speed and position.
Adjust machine power and current settings, including acceleration and speed.
Step-by-step guide for storing data within the Set menu, detailing button presses.
Select machine type (left/right), battery type, path, and speed parameters.
Step-by-step guide for storing data within the Configuration menu.
Manage saving up to 9 settings and downloading them to the motor control.
Define floor data, deceleration zones, and parking locations.
Procedure for storing floor data (park/slow zone) in manual mode.
Procedure for storing floor data (park/slow zone) in self-learning mode.
Record and log up to 20 malfunctions, including error type and time.
Select console language, contrast, and brightness settings.
General| Brand | vimec |
|---|---|
| Model | V59 |
| Category | Lifting Systems |
| Language | English |
To Next Page
