VIOMI Alpha 3 - Page 17

Reset Wi-Fi
When your router or Wi-Fi access password has been changed, you have to
reset your Wi-Fi connection by pressing and holding both " " and " "
for 7 seconds when this product is power-on, and Wi-Fi connection is reset
successfully when a voice prompt "Wi-Fi reset and network configuration
activated" is given.
Tips: Only Wi-Fi network in 2.4GHz frequency is available to this product.
Carpet identification
Aer the carpet is identified in the cleaning process of the sweeping and
mopping robot, the suction enhancement will be automatically turned on
and the mop is lied, and this function can be turned off by using APP; or
turn on the carpet avoidance function in the APP, and the sweeping and
mopping robot will automatically bypass the carpet for cleaning.
Tip: For children’s floor mats, yoga mats, sponge mats and hard short-haired
carpets, there may be misjudgments, which will not affect the normal use.
Virtual walls/forbidden zones can be set to prohibit the main machine from
entering areas that do not need cleaning.
Sleep
Unless during charging, the main machine will go to sleep automatically
when it is le idle for 5 minutes; it will be powered off automatically when
it has slept for 6 hours without appointment. In sleep status, press any
buon or APP will wake main machine up.
Tips: Main machine will not go to sleep on the cleaning station.
Reset/Recover system
Press the reset buon for 3s with a needle, and when you hear “successful-
ly reset the system”, the main machine will restart automatically, and
relevant seings such as scheduled cleaning and Wi-Fi will be recovered to
the factory state.
Press the reset buon for 10s with a needle, and when you hear “success-
fully recover the system”, the main machine will restart automatically, and
the relevant seings such as scheduled cleaning and Wi-Fi will be
recovered to the factory state, and the system will be recovered to the
previous firmware version.
Tips: Aer reseing/recovering the system, the main machine needs to
reconnect the APP, and the relevant seings in the APP are cleared.
Non-Disturbance Mode
When non-disturbance mode is activated, proceeding at breakout point,
scheduled cleaning and active voice reporting are unavailable for the main
machine. Non-disturbance mode is activated by default during the period
from 23:00 to 9:00. Non-disturbance mode can be deactivated in APP.
“During non-disturbance time period, the indicator light turns off aer the
main machine is charged for 1 minute. ”
Fixed-point cleaning
When choosing fixed-point cleaning and choose a target point in APP, the
main machine will route cleaning task and start cleaning within a rectangu-
lar area of 2m × 2m based on the target position defined in the map in App.
Specified-area cleaning
When an area to be cleaned is defined in APP, the main machine will clean
the defined area.
Tips: During cleaning, the main machine may go beyond a defined area, so
be sure to remove any obstacle on the floor within defined area since
definition of any area will not ensure safe separation.
14
Operation