VIOMI Alpha 3 - Page 19

16
Main Brush
1. Turn over the main machine and press the two release buons to
remove the main brush cover.
2. Take out the main brush upward.
3. Pull out the main brush axle sleeve outward.
4. Rotate the main brush bracket so that the alignment identification on
the main brush bracket is aligned with the unlocking identification and
remove the main brush brackets at both ends of the main brush.
5. Cut the hair wound on the main brush with a knife on the cleaning tool
and clean the main brush.
6. Install main brush bracket and main brush axle sleeve back.
7. Replace the main brush and main brush cover, and press the main
brush cover to install it in place.
Product Maintenance
Dirty water tank/Sewage mesh
Take out the dirtywater tank and dump the dirtywater; li up the cleaning
brush and take out the sewage mesh for cleaning.
Sewage mesh
(Alignment with the slot
with magnetic installation)
Cleaning brush
Cleaning slot
Tips:
1. Aer mopping the floor, please take out and clean the dirtywater tank
in time, and clean the cleaning brush, cleaning slot and sewage mesh to
avoid odor and mildew.
2. Clean the sewage mesh regularly to prevent hair and dirt from blocking
the drainage hole.