4.
Pinch the clips, install the mop holder horizontally into the boGom of the vacuum-mop, as illustrated.
5.
Turn on the vacuum-mop. It is now ready to start vacuuming and mopping.
Precautions:
1.
Do not place the charging dock in an area with direct sunlight.
2.
Make sure there are 0.5 meters or more of open space on either side of the charging dock and more than 1.5 meters in front.
3.
If the vacuum-mop is unable to turn on due to low baGery, place it directly onto the charging dock to recharge.
4.
The vacuum-mop will automatically turn on when it is on the charging dock.
5.
The vacuum-mop cannot be turned off when it is on the charging dock.
6.
Remove 2-in-1 dust compartment with water reservoir and mop holder when the vacuum-mop is charging or not in use.
7.
Use the virtual wall or set restricted areas for carpeted areas to prevent the vacuum-mop from geGing caught on the carpet.
8.
Regularly clean the 2-in-1 dust compartment to prevent excess dirt accumulation. This can avoid reducing the cleaning performance of the vacuum-mop.
To Next Page
Loading...
Need help?
General
