1.
Open the cover of vacuum-mop,
remove the 2-in-1dust compartment
with water reservoir, thenremove
the filter as shown in the figure.
3. Reinstall the 2-in-1 dust
compartment with water reservoir
into the vacuum-mop until it clicks
into place, then close the cover of
the vacuum-mop.
2.
Empty the contents of the dust
compartment. Clean the
compartment using the cleaning
brush, then align and reinstall the
filter.
To clean the filter in 2-in-1 dust
compartment with water reservoir,
remove it as indicated in the diagram.
•
Aher rinsing the filter with water, make sure it is thoroughly dry when
reinstalling the filter into 2-in-1 dust compartment with water
reservoir.
•
To prevent the filter from becoming clogged, it is recommended to
regularly clean the filter using the cleaning brush.
•
It is recommended to replace the filter every 3 to 6 months.
Main Brush
Main Brush Guard
Clips
Main Brush
Main Brush Bearing
1.
Flip the vacuum-mop over and
pinch the clips to remove the main
brush guard.
2.
Remove the main brush and the
main brush bearing.
3.
Use the cleaning brush to clean
the mainbrush.
4.
Reinstall the main brush and its
bearing, then put back and press
down the main brush guard until it
locks intoplace.
Note: It is recommended to replace the main brush every 6–12 months for optimal
cleaning effectiveness.
To Next Page
Loading...
Need help?
General
