10
Section 6: Basic Operation
1. Insert one end of the DP cable (included) into your PC’s graphics card. An HDMI
cable (not included) may also be used.
2. Connect the other end of the cable to the corresponding port on your monitor.
HDMI Ports
Audio Out
DP Port
3. Connect the power cable to your monitor, then connect the other end to your
power source. It is recommended that you use a surge protector with adequate
voltage if a wall outlet cannot be reached directly.
4. Locate the power button on the monitor and press and hold it for ~6s to turn the
monitor on.
If you cannot locate the power button, please refer to Section 3.1.
AMD FreeSync
The feature itself is off by default. In order to use this feature, please note you must
have hardware with FreeSync capability, a DP cable, and the latest graphic drivers.
To use this feature, connect your computer and monitor with a DP cable. After
connecting, you may receive a prompt to enable the feature on your computer. If
you do not receive the prompt, you may need to enable the function in your graphics
card menu. See your graphics card manufacturer’s documentation for instructions
on how to turn on and/or enable FreeSync.
Section 7: Indicator Light
Solid blue light indicates power is on and the
monitor is operating normally. Flashing blue
light indicates no video source, no horizontal
or vertical signal has been detected or voltage
is low. Please ensure your computer is on
and all video cables are fully inserted and/or
connected.
Indicator Light
To Next Page
Loading...
