17
Dim image
• Adjust the brightness and contrast ratio.
Image jitter/moire pattern
• Nearby electric equipment may be interfering with the monitor.
Light indicator is on or flashing, but there is no image displayed on screen
• Check if the monitor power is on.
• Check if the graphics card is installed properly.
• Make sure the power cable is properly connected to the monitor and power
source.
Image position is not centered/the size is not right
• Please adjust Clock or Auto settings.
Color difference (colors are not optimized)
• Adjust RGB color settings or reset color temperature.
11.2 – PIP (Picture in Picture) Input Information
Mode Primary
Screen
Source
Picture in Picture Additional
Source
Swap
Windows
Picture
Mode
DP HDMI Type -C
Mode 1 DP X
Mode 2 HDMI X
Mode 3 DVI X
Note: ” ” means this feature is supported while “X” means it is not supported.
11.3 – PBP (Picture by Picture) Resolution Information
For optimal viewing experience while using these features, it is recommended to set
both panels to the same resolution, unless in Phone PBP mode.
It is recommended to set
the rst panel to 960 x
1080 resolution.
1
It is recommended to set
the second panel to 960
x 1080 resolution.
2
To Next Page
Loading...
Need help?
General
