7
Section 4: Stand Installation
Keep the foam underneath the monitor while attaching the stand.
1. Open the package, take out the product with foam still attached, and gently
place it on a desktop or table.
Monitor
Stand Base
Foam
Foam
Stand Stem
2. Take out the two main parts of the stand and remove the foam covering the top
of the monitor. Release the screw attached on the base, then attach the stand
base to the stand stem. Tighten the screw back to the base.
Stand Base
Screw x 1
Stand Stem
3. Remove the foam covering the back of the monitor. Locate the top slot of the
opening on the back of monitor. Insert the mounting plate into the top slot.
Continue to press in until it clicks into place to make sure the stand is installed in
place.
To Next Page
Loading...
Need help?
General
