38
© 2005 directed electronics, inc.
is not used (ignition is not turned on) for a period of one
hour while the system is in Valet
®
Mode, the LED will shut
off. If the system remains in Valet
®
Mode, the LED will
come back on the next time the ignition is turned on and
then back off.
pprrooggrraammmmiinngg
Programming options control what your system does during
normal operation, and require few or no additional parts.
However, some may require additional installation labor.
The following is a list of the program settings, with the factory
settings in
BBoolldd::
➤
AAccttiivvee aarrmmiinngg
(only with the remote) or passive arming (au-
tomatic arming 30-seconds after the last door has been
closed).
➤ Arming/disarming confirmation siren chirps
oonn
or off.
➤ The ignition controlled door lock feature
oonn
or off: With
this feature on, the doors will lock three seconds after the
ignition is turned on, and the doors are closed, and unlock
when the ignition is turned off. The system will not lock the
doors when the ignition is turned on with any door open. If
your installer is programming the security system with the
Directed Bitwriter, ignition lock and unlock are indepen-
dent features and can be programmed separately.
➤ Passive door locking (with passive arming) or
aaccttiivvee ddoooorr
lloocckkiinngg
(only when arming with the remote). Passive locking
To Next Page
Loading...
Need help?
General
