Viper 350 Plus - H1;9 YELLOW - Ignition Input; H1;10 BROWN

To Next Page

To Previous Page

grounded at the same location.

H1/9 YELLOW (+) ignition input

Connect this wire to the (+) 12 volts ignition wire. This wire is pre-wired to

the starter kill relay and must show (+) 12 volts with the key in RUN position

and during cranking. Take great care that this wire cannot be shorted to the

chassis at any point.

\\\\\\\

H1/10 BROWN (+) siren output

Connect this to the RED wire of the Revenger® siren. Connect the BLACK

wire of the siren to (-) chassis ground, preferably at the same point you connect

the control module’s BLACK ground wire.

Viper 350 Plus - H1;9 YELLOW - Ignition Input; H1;10 BROWN - Siren Output